Finished speaker dimensions: 10" x 6.5" x 8" (HxWxD)
Weight: 10.5 lbs (each)
Minimum Recommended Amplifier Power: 15 Watts RMS
Maximum Recommended Amplifier Power: 200 Watts RMS
Tweeter: 1" fabric soft dome, neodymium magnet, large volume back chamber for low resonance, low profile faceplate for minimum diffraction and wide dispersion
Woofer: 5.25" coated wool and paper cone, glass reinforced anti-resonant polymer basket, butyl rubber surround, low loss, linear CONEX-cotton blended spider, OHFC high purity copper voice coil wire, XBL motor structure, copper shorting ring embedded in the top plate, aluminum shorting ring embedded inside the magnet
Crossover: Proprietary symmetrical second order (Linkwitz-Riley) 12dB per octave electronic (18dB per octave acoustic) network centered at 2.7kHz
Frequency Response: 75Hz-20,000Hz
Nominal Impedance: 8 Ohms
Sensitivity : 86dB 2.83V@1m
Cabinet Construction: 3/4" Medite II formaldehyde free, fully recycled MDF
Environmentally friendly bamboo cabinet fill material
Mirror image cabinets for great imaging (if you need a single speaker for use as a center channel please call and we can make a symmetrical cabinet for you)
EK (Electronics Kit) consisting of all the parts you need (woofer, tweeter, crossover, back cup, wire and filler). Does not include the cabinet.
This kit is for the person who wants to build and finish their own enclosure. We provide the dimensional information needed for the speaker to perform optimally, the rest is up to you.
UKM (Unfinished Kit, MDF) consisting of the Electronics Kit, plus an unfinished MDF cabinet and fasteners. This kit is for the person who wants to just put the finish on a cabinet (or leave it raw) and assemble their speakers - this is the quickest and least expensive way to great sound!
UKV (Unfinished Kit, Veneer) consisting of the Electronics Kit, plus an unfinished veneered cabinet and fasteners. This kit is for the person who wants to just put the finish on a cabinet (or leave it raw) and assemble their speakers! We chose a veneer that takes stain well, so you can stain it the color you want.
* Contact us for orders outside the United States
For questions or custom configurations please contact us
Speakerlab 6220 Roosevelt Way NE Seattle, Washington 98115 USA
Tel: (206) 523-2269 Fax: (206) 523-2389 Email: firstname.lastname@example.org